A report that says “20 percent damaged” leaves an important question unanswered: 20 percent of what? A percentage might describe one photograph, one slope, the slates examined at close range or the entire roof. Those statements can lead to very different decisions.
The National Slate Association’s condition-assessment guidance describes counting affected slates and evaluating the slate, fasteners and flashings together. The arithmetic below is an original teaching example, not a survey of a real building or a prescribed sampling method.
Keep each counted population visible
Imagine two areas that an inspector has fully counted using the same definition of “affected.” Area A contains 300 slates, with 60 affected. Area B contains 900 slates, with 45 affected. A further area has not been inspected adequately and has no reliable condition count.
- Area A: 60 ÷ 300 × 100 = 20 percent.
- Area B: 45 ÷ 900 × 100 = 5 percent.
- Combined counted areas: 105 ÷ 1,200 × 100 = 8.75 percent.
Averaging the two percentages gives 12.5 percent, which is wrong for the combined count because the areas contain different numbers of slates. The 8.75 percent figure is correct only for the 1,200 counted slates. It is not a whole-roof result while another area remains unassessed. Nor does it erase the concentrated problem in Area A.
Avoid counting the same slate twice
Suppose the inspector records 40 cracked pieces and 30 slipped pieces, but ten appear in both groups. There are 60 distinct affected slates, not 70. A report can retain both defect categories while using a separate count of unique pieces for the overall percentage. Location identifiers or annotated photographs help make that distinction reviewable.
The report should also distinguish individual-piece counts from square footage. A roof containing different slate sizes cannot automatically convert one measure into the other. If quantities were estimated rather than counted, label the result as an estimate and explain the method.
Ask what the number can support
A close view deliberately aimed at a leaking chimney may be valuable diagnostic evidence, but it is not automatically representative of every slope. Ask the assessor to identify the surveyed population, selection method, inaccessible areas and uncertainty before extrapolating.
No percentage in this example determines whether repair or replacement is appropriate. Condition, distribution, underlying components, access and the proposed scope still need professional assessment. Use the inspection-report guide to organize that discussion, and Slate Roofing USA for natural-slate resources. If the property also has clay or concrete roofing, Tile Roofing USA provides a separate starting point; do not combine different systems into a single unsupported defect percentage.
