Preserving the craft. Building its future.

Slate · Submittal review

How long did the slate assembly face the highest wind speed in the test?

Read the duration and test method beside the speed before using a laboratory report to support a roofing submittal.

By the Slate, Tile & Metal Guild ·

A supplier hands the architect a report whose last row says 160 mph. The project form asks for a wind classification and the approved attachment detail. Copying the last row into both spaces loses two important facts: how long that speed was applied and what was actually fastened to the test deck.

Keep the two parts of the test on separate lines

In the laboratory report published by the National Slate Association, two specimens passed the ASTM D3161 Class F test at a nominal 110 mph for two hours. The lab then reported a modified series, increasing the speed in steps. Each interval lasted ten minutes. Both specimens passed the 160 mph interval. Giving that figure the two-hour duration, or describing it as a separate ASTM class, changes the result.

The sketch attached to the submittal matters as much as the number. The report describes an 8:12 slope, a plywood deck, copper nails and a stated exposure. Suppose the project detail shows boards, a different nail and a different exposure. On the review copy, put those differences beside the tested construction. Send that comparison to the responsible designer to determine whether the evidence supports the proposed assembly at this building. A fan speed alone cannot settle the allowable design pressure at a roof corner.

Keep the report with the accepted detail so a future reviewer can trace the decision. For help organizing the supporting paperwork, use the Guild network’s guide to reading slate test reports.

Further reading

National Slate Association · PRI wind resistance test report, specimen details and results. Results apply to the specimens and conditions described in the laboratory report.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles