Preserving the craft. Building its future.

Slate · Estimating metalwork

What does “16-ounce copper” buy for a slate roof valley?

Use the width of the flat copper blank to check a valley estimate and see why two bids with identical copper weights can include different quantities.

By the Slate, Tile & Metal Guild ·

The drawing calls for copper in a slate roof valley. One bidder writes “16 oz copper, 30 linear feet.” A second writes the same thing and allows three times as much copper. Before questioning the price, ask each bidder how wide a flat sheet they allowed before the metal is formed. Both can be quoting the same thickness.

Unfold the section on paper

The Copper Development Association lists 16-ounce sheet at a nominal 0.0216 inch thick. The ounce figure is the weight of one square foot of sheet. The valley length on a roof plan gives only one dimension of that sheet. Its developed width is the full width across the flat blank, including material that will be concealed or bent in the finished section.

For a quantity check, suppose the specified blanks add up to 30 feet of cut length, with a developed width of 24 inches. Converting the width to 2 feet gives 60 square feet of copper. At 16 ounces per square foot, the blanks weigh about 60 pounds. Using just the hypothetical 8-inch strip visible between the slate edges would yield 20 pounds. The gap comes from measuring different parts of the same assembly. Neither width in this example is a design recommendation.

Ask where the allowance begins

A measured 30-foot valley on the building is a different starting point from 30 feet of scheduled cut lengths. Ask whether the cut list already includes laps and end details before adding them again. Ask separately about coil offcuts, fabrication, and the slate that must be lifted and reinstated for access. The weight check can expose a mismatch in sheet quantities. It cannot price the work of opening and closing the roof.

Keep the dimensioned metal section beside the revised quote so the awarded scope shows what disappears under the stone. Slate Roofing USA’s valley replacement guide covers coordination with the surrounding slate.

Further reading

Copper Development Association — Copper in Architecture Design Handbook. The handbook relates copper sheet weight per square foot to nominal thickness. The example uses assumed dimensions for arithmetic only.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles