Preserving the craft. Building its future.

Slate roofing · Workmanship review

Which cut edge should the open slate valley sample show?

Use an oblique view of the finished cut to review the visible bevel as well as the straightness of an open valley.

By the Slate, Tile & Metal Guild ·

A photograph looking straight down a valley can show a remarkably straight line. It says less about the surface that will catch the light along that line. On an open valley, each diagonal cut exposes a new edge beside the metal, and a square sawn face can read as a bright stripe even when the layout is accurate.

The Slate Roofing Contractors Association describes cutting slate for an open valley so that the exposed face retains its bevel, also called a chamfer. Its guidance addresses the appearance of the finished edge when mechanical cutting is used. Knowing which tool the contractor owns answers a different question from knowing what the completed cut will look like.

Ask to see the edge in its installed orientation

For a workmanship review, ask the slater to place an example cut piece against a short sample of the valley metal. Identify the weather face and the side of the valley represented. View it first along the valley to judge the line, then from the side under raking light to see the cut profile. Include an uncut factory or quarry edge from the same delivery for scale and texture. The two edges need to be identified in the photograph so a later reviewer knows which one the installer made.

Write down which visible cut the review covers. A sample made for two slates meeting at a closed valley serves a different condition. Keep the approved example and the photographs with the slate submittal record until the open valley can be compared with them.

Further reading

Slate Roofing Contractors Association of North America · General Installation Guidelines for Natural Quarried Roofing Slate, sections 4.4.G–H. The guideline discusses exposed edge treatment and the different treatment possible at certain concealed or meeting edges.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles