A roof plan has a straight line across the slate field with the note “change of pitch.” A second line on a different slope carries the same note. Before pricing one flashing profile for both, draw a section perpendicular to each line. Two transitions that look identical from above can bend in opposite directions.
Start at the ridge and trace the surface in the direction rain travels. Where a shallow upper slope tips over onto a steeper lower one, the surface bends outward. A mansard commonly has this convex profile. A steep slope that flares onto a gentler eave bends inward. In either case rain crosses the line from the upper slates to the lower ones. On a ridge, water drains away on both sides.
Pair each plan mark with its section
Samaca’s natural slate guide illustrates the two changes separately. Its discussion of an inward bend distinguishes a slight change, where course spacing may be adjusted, from a pronounced one detailed with a flashing. A single elevation taken straight on can hide the difference.
Put the two slopes and a downhill arrow on each section. Have the designer show where the upper course ends, how the lower course is supported, and which portion of any metal will be visible. Key each section to its own plan line before the sheet-metal shop draws a profile. The Slate Roofing USA section-drawing guide can help an owner follow the layers during review.
