Preserving the craft. Building its future.

Slate · Course layout

Ten slates fit across the drawing. Will they fit across the roof?

A bench layout can reveal the width contributed by side joints before the slater reaches a fixed boundary.

By the Slate, Tile & Metal Guild ·

A drawing shows ten nominal 10-inch slates between two marks 100 inches apart. Before the shop cuts the pieces at the ends, the slater can check that course on a bench. Ten stones create nine internal joints. If the stones measure exactly 10 inches wide and the trial joints average 1/8 inch, the run measures 101⅛ inches before either end detail. The extra inch and an eighth can matter at a dormer cheek.

The National Slate Association gives 1/16 to 1/8 inch as a typical slight separation for neighboring slates and describes conditions where the spacing differs. Thickness, width, exposure to weather and regional practice can all affect the choice. Two side edges that inadvertently ride over one another on a standard roof can leave a slate vulnerable to breakage.

Read the trial row in both directions

Have the slater lay out representative stock to the intended joint spacing. Record the span along the tails and again toward the heads. A stone that tapers can leave a joint open at one end and crowded at the other. Include any clearance the actual verge or wall detail needs separately from the nine internal joints.

Where the trial runs long, give the designer or slater the measured excess while there is still room to adjust the widths or cuts. Check the neighboring course at the same time so a solution at the boundary preserves the intended bond and cover over fasteners. The guide to slate dimensions and exposure explains the separate dimensions measured up the roof.

Further reading

National Slate Association · Technical Bulletin No. 2, Vertical Joint Spacing. The bulletin addresses adjacent slates within a single course. Its examples cover a range of roof conditions.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles