Preserving the craft. Building its future.

Clay tile · Owner maintenance

There is sand below the downspout. Is the new clay roof losing its face?

Record the finish, timing and location before deciding what a deposit of loose grains tells you about new handmade plain tiles.

By the Slate, Tile & Metal Guild ·

A small fan of sand beneath a downspout can look alarming after an expensive reroof. Before opening a defect claim, pull out the tile order. Was the selected clay tile sand-faced? Tudor Roof Tile Co. explains that some face sand comes away from newly installed sand-faced tiles in their first few months outdoors. The visible grains alone tell you little about how much material, if any, the fired clay body has lost.

Give the roofer something to compare

From a safe spot on the ground, photograph the deposit with a scale, date the picture and identify the outlet. A downspout serving several roof faces collects material from all of them. Include a wide view showing what drains to it. Check the installation date and keep the product name and finish beside the photograph. If the outlet is observed again after rain, photograph it from the same position and note whether the earlier deposit had been cleared.

Fine grains shortly after installation and pieces bearing the profile of a tile edge are two different observations. A visibly cracked or displaced tile, a new leak or continuing unexplained debris merits a roofer’s assessment on its own evidence. There is no need to climb up or scrub a tile to produce a sample. File the dated observations with the clay roof maintenance record so a later inspector can see what changed.

Further reading

Tudor Roof Tile Co. · Care & Maintenance Guide, initial weathering and visual inspection. The maker describes its handmade plain tiles. A ground-level observation cannot identify the source of every grain or establish the condition of a particular roof.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles