After salvaged slates go back on a roof, a narrow band can appear below the next course. It may be the boundary between the part of the stone that weathered outdoors and the part previously covered. The National Slate Association illustrates this effect in a repair above a metal roof. Extending the exposed face revealed a strip that used to be hidden.
The stripe also raises a question about headlap, the distance a slate overlaps the head of the slate two courses below. For equal-length slates laid to a uniform double-lap pattern, changing the exposure changes that overlap twice as much. Suppose 20-inch slates were set at an 8-inch exposure. The headlap was 20 minus twice 8, or 4 inches. Reset them at 8¼ inches and the headlap becomes 3½ inches. A quarter-inch change at the lower edge took half an inch out of the overlap.
Recover the earlier measurement
Have the slater compare the repaired area with an adjoining undisturbed course of the same slate length. If the entire slope was stripped, look for a measured survey or a labeled piece retained from that slope. A photograph of a stripe without a scale or known slate length cannot establish the installed headlap.
Record the earlier and current exposures, the stone length and the repair location. Check the resulting overlap against the project requirements before deciding whether the appearance signals a problem. The Slate Roofing USA exposure calculator provides a second arithmetic check for the regular field courses.
