Two hooks on the counter may have the same reach from the batten to the tail of the slate. If one has a wavy shank and the other is straight, the difference deserves a line on the substitution request. A tape measure along the length misses the feature the designer may have selected.
Irish supplier Classic Natural Slate explains that a crimp in the shank lies in the plane of the roof and reduces water rising by capillary action in the joint between neighboring slates. The bend at the upper end serves a different purpose. A spike-ended hook drives into the batten, while a wrap-type hooks over it. Writing just “bent hook” leaves the buyer guessing which part of the fastener the drawing describes.
Match the part to the roof plane
Suppose a main slope and a shallower porch appear on the same order. Record the pitch and headlap at each location, then identify the approved hook for each. SIG Roofing’s UK natural slate guide specifies crimped spike-end hooks for certain lower pitches and gives a lower limit for its hook method. A hook approved on the main slope does not establish approval on the porch. For a U.S. project, use the project designer’s applicable fastening detail.
Have the supplier return a part number, dimensioned sketch and applicable product guidance for any alternative. Keep the approval beside the installation drawing so stock for the two slopes can be identified on delivery. The Slate Roofing USA directory can help a project team find a slater familiar with the specified method.
