Preserving the craft. Building its future.

Slate · Sheet-metal coordination

Where do the clamps land on a metal-capped slate ridge?

Lay the clamp marks over the metal section joints before approving a ridge-cap shop drawing.

By the Slate, Tile & Metal Guild ·

One drawing shows the metal ridge cap broken into sections. Another shows a neat row of clamp symbols. Viewed separately, both may look reasonable. Put the two rows on the same elevation and a clamp can land directly over a joint between pieces.

For its clamped metal ridge and hip flashing detail, the National Slate Association calls for locating clamps along each individual length, clear of the overlaps between lengths. The reason is movement as the metal warms and cools. A clamp straddling an overlap changes the restraint where the two pieces meet. A separate expansion clip, when the design calls for one at a seam, serves a different purpose.

Review one full run on paper

Ask the fabricator to draw the run from a fixed landmark such as the gable end. Mark the beginning and end of each metal piece, including the full length of the concealed overlap. Have the installer add clamp locations to that same drawing. At a hip junction or a short closing piece, check the marks again. A repeated spacing measured from one end may have worked on the first full-length section only.

If a clamp falls within a lap, return the marked drawing for a coordinated layout and approval before the metal is punched. Keep a dimensioned copy with the owner’s flashing and fastener records. A later repairer will then know which marks identify clamps and where the hidden ends of the metal lie.

Further reading

National Slate Association · Mobile Field Guide, metal ridge and hip flashings. The association describes distributing clamps along each flashing section and keeping them clear of laps to accommodate thermal movement.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles