Preserving the craft. Building its future.

Clay tile · Historic ornament

Which width belongs on a drawing of a clay tower finial?

Use the base width, ornament spread and overall height to test whether a catalog finial is a plausible match.

By the Slate, Tile & Metal Guild ·

A photograph of a tower can preserve the outline of a lost clay ornament while telling you little about the width of its base. That distinction matters when a restoration drawing has a single dimension labeled “finial width.” A model maker might use it for the part that meets the roof. A historian looking at the same photograph might have measured the spread of a flourish near the top.

On page 108 of Ludowici’s historical catalog, finial 525 has an 18-inch base, a 5-inch spread and a height of 33 inches. Finial 524 has a 22-inch base, a 7-inch spread and a height of 39 inches. Both entries describe ornaments for large round towers. A general description of the building and a rough height leave both candidates in play.

Mark where each dimension was taken

Ask the survey team for a dimensioned outline with arrows showing the base, the ornament spread and the overall height. Label measurements taken from surviving fabric separately from estimates scaled from a photograph. Check the base against the surviving tower top before asking for a replica. Keep the catalog number as a candidate until the evidence supports it. The plate records historical dimensions. The factory can confirm what it can supply today. For other unidentified pieces on the same roof, see the tile identification guide.

Further reading

Ludowici — Historical Roofing Tile Book, printed page 108, finials 524 and 525. The source documents the specific example discussed above.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles