Preserving the craft. Building its future.

Slate · Drawing review

Does the slate headlap table cover the full length of this slope?

Measure the sloping rafter and check the driving-rain exposure before transferring a minimum lap to the roof schedule.

By the Slate, Tile & Metal Guild ·

A designer extends a building by carrying the existing roof plane farther downhill. The pitch stays the same, so the old headlap is copied onto the extension drawing. One other dimension has changed. Welsh Slate places limits on the length of rafter covered by its normal minimum-pitch and lap recommendations. The length runs along the slope. A horizontal dimension on the floor plan is a different measurement.

Compare two roof sections

Imagine two roofs at the same pitch, both specified with the same slate. One has a 5.8 m rafter and the other a 7.2 m rafter. In severe driving-rain exposure, the manufacturer gives 6 m as the usual upper length for its recommendations. The short rafter passes that particular check. The long one needs a project-specific answer. In moderate exposure, the published length limit is 9 m, so both lengths fall within that limit. Pitch, slate size and actual site conditions still matter in either case.

On the drawing sent for review, mark the eave and ridge, the measured rafter length and the exposure classification used. Ask the designer and slate supplier to settle the required lap for the longer slope before setting the course spacing or releasing a quantity. If the lap changes, revisit the relationship between slate length, exposure and headlap. A takeoff prepared from the shorter slope may no longer buy enough stone.

Further reading

Welsh Slate · Slate Headlap, scope of UK minimum pitches and laps. The lengths describe the normal scope of this manufacturer’s UK recommendations. The two roofs below are hypothetical.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles