Preserving the craft. Building its future.

Clay tile · Roof layout

Can the clay tiles finish at both verges without a narrow strip?

Use the sideways adjustment in the specified tile’s interlocks to check an end cut while the verge detail can still be changed.

By the Slate, Tile & Metal Guild ·

A gable drawing shows full tiles running neatly from one end of the roof to the other. That drawing can be hard to build if its author divided the roof width by the overall width of a loose tile. Part of each tile disappears into its neighbor’s side joint. The usable width also depends on how the interlocks seat.

Marley’s October 2024 sitework guide gives the Lincoln clay tile an average covering width of 224 mm and describes up to 3 mm of lateral play in the side interlocks. Roofers call this play “shunt.” The guide uses marks from a group of tiles set at the extremes of their movement to establish an average setting-out width. It advises avoiding cut verge tiles where possible and calls for at least half a standard tile’s width if a cut is necessary on this model.

Check the two ends together

Ask for a sketch across one complete course showing the start piece, the repeated cover width and the opposite end piece. Locate each verge against the actual finished gable detail. A wider first piece can consume the width needed for the last one. Have the installer check the proposed arrangement with samples of the specified tile before the verge fittings are released.

If the adjustment leaves an end piece outside the manufacturer’s limit, put the discrepancy back to the designer while the junction can still change. Keep the accepted course sketch with the field tile and fitting quantities. A change of profile requires a fresh width check even if the new tile looks the same length.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles