Preserving the craft. Building its future.

Clay tile · Ordering roof fittings

Four hips, one ridge: how many clay junction fittings?

Count the junctions on a hip roof plan and give the supplier a drawing that distinguishes a three-way terminal from a closed ridge end.

By the Slate, Tile & Metal Guild ·

Draw a simple rectangular hip roof with a short horizontal ridge. From each of the two ridge ends, draw hips down to the nearest pair of eave corners. You can now count four hips, four lower hip ends and two upper junctions. Ordering four three-way terminals because there are four hips would double the number of junctions on this roof.

Describe each arm of the junction

Ludowici’s Heritage sheet shows a hip roll starter, hip roll, running ridge, closed ridge end and intersection terminal. Those names let a buyer ask more precisely for the piece seen from the ground. At the top junction in the sketch, two descending hip runs meet one horizontal ridge run. A closed end for a ridge terminating on its own would answer a different condition.

Give the two junctions labels on the plan. For each, note the profile approaching on each arm and mark the direction toward the eave. Ask the supplier to identify the fitting on a marked-up drawing and confirm the configuration and pitch it fits. A description such as “three-way” leaves open which three runs are meeting. A catalog number without the roof sketch can leave the same question unanswered.

Keep the running feet of hip and ridge on their own estimate lines. Changing the length of this rectangular building can lengthen its ridge while leaving its two junctions intact. On an existing roof with unidentified trim, the Tile Roofing USA matching guide can help document the adjoining profiles before fittings are ordered.

Further reading

Ludowici — Heritage Closed Historic Tile product sheet. Consult the project specification and the supplier’s current documentation for the selected product.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles