Preserving the craft. Building its future.

Concrete tile · Moisture design

The underlay is vapour-open. Is the concrete tile covering air-open too?

Ask for evidence about the laid tiles before using an underlay data sheet to approve a ventilation detail.

By the Slate, Tile & Metal Guild ·

A supplier proposes a concrete tile substitution on a UK project. The ventilation detail shows vapour-permeable underlay, and the supplier encloses the same membrane data sheet already in the file. That establishes what is staying beneath the battens. It leaves a separate question about how readily air passes through the laid tile covering.

Glidevale Protect illustrates two roof sections with vapour-permeable underlay. Where the outer covering is insufficiently air-open, its illustration includes a ventilated counterbatten space. The manufacturer advises checking the covering with the tile supplier. A declaration for the membrane cannot describe the joints between tiles above it.

Read the area alongside the airflow

The paper describes a UK criterion using airflow at a 10 Pa pressure difference. The threshold in cubic metres per hour is 17.4 times the tested covering area in square metres. Suppose a test report gives 40 cubic metres per hour through 3 square metres at that pressure. The comparison is with 52.2, so that example falls below the threshold. Comparing 40 directly to 17.4 would reverse the conclusion.

Ask for the test pressure, specimen area and identification of the laid tile assembly. Pass the result to the designer responsible for moisture control, together with the proposed tile roof underlayment and roof section. If the evidence changes the ventilation detail, identify the space and openings on the revised drawing before pricing the substitute.

Further reading

Glidevale Protect · BS 5250 white paper, Other considerations and roof sections. The manufacturer illustrates UK moisture-design practice. The worked comparison is hypothetical. The project designer determines the applicable ventilation provisions.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles