The architect wants the joints on a flat concrete tile roof to line up with the window mullions below. The drawing shows a continuous vertical joint. Beside it, the specification names a tile that the manufacturer illustrates with every other course offset. Both arrangements might fit on the sample board. Which arrangement did the manufacturer use when it assessed the roof?
Wienerberger UK gives a specific example in its guidance on bond. Its flat interlocking Calderdale Edge can physically be arranged with aligned joints. For that product, however, the minimum pitch guidance comes from wind-driven rain tests on staggered courses. The fixing specification also draws on uplift tests on staggered courses. The manufacturer reports that it has not measured performance with straight joints for this tile.
Resolve the drawing before the roof is set out
On a copy of the elevation, mark the two side edges of a whole tile in one course. Mark the tile edges immediately above. Send the sketch, model name, project pitch and the product sheet to the specifier. Ask them to confirm the joint pattern before the roofer prices the edges or starts setting out the courses.
If the selected product stays, revise the elevation to show its specified bond and revisit the meeting point with the windows. If continuous lines are essential, have the designer identify a product documented for that layout and review its pitch and fixing requirements. A designer’s signature on a colour sample cannot supply the missing test evidence. Keep the resolved elevation with the tile installation checkpoints used at the start of work.
