Stand two loose tiles upright with their heads level and the tails may line up perfectly. On the roof, each tile hangs from a small projection on its back called a nib. If those nibs sit at different distances from the head, the tails will land in different places on the same batten.
Marley’s UK guidance measures hanging length along the back, from the underside of the nib to the tail. Its plain-tile layout checks both the standard field tile and the under-eaves piece. The aim is to see where the lower edges of both courses actually finish over the gutter.
Try the two pieces on the same bench batten
Ask the roofer to hang an original loose tile and the proposed replacement side by side on a sample batten. Suppose the original measures 240 mm from bearing point to tail and the replacement measures 233 mm. On that common support the new tail ends 7 mm uphill, even if both tiles have the same overall length. Record the two hanging lengths and photograph the tile backs with the bearing points marked.
Then have the roofer check the intended field and under-eaves pair against the project’s eave section. A bench comparison can reveal the mismatch before anyone moves a batten or orders a pallet. Include the bearing-point dimension with the other measurements in the clay tile submittal.
