Preserving the craft. Building its future.

Clay tile · Eaves design

Which pitch should be marked on a drawing of a flared clay-tile eave?

Check the shallow section of a bellcast eave when selecting clay plain tiles for a roof with a steeper main slope.

By the Slate, Tile & Metal Guild ·

The architect’s elevation shows a steep roof that sweeps outward just above the gutter. This shape, often called a bellcast or sprocketed eave, gives the lowest courses a shallower slope. A product submittal bearing the angle of the main roof can look complete while leaving the most exposed part of the drawing unchecked.

Ask for a section through the change of slope. Mark the pitch of the main plane and that of the shallowest tiled section. Alongside them, identify the minimum permitted pitch for the exact clay tile, its proposed lap and the exposure conditions on this project. The UK Roof Tile Association uses 35 degrees as a reference minimum for plain tiles in its bellcast detail and notes that some handmade tiles require 40 degrees.

Read the two angles against the same product sheet

Imagine a section marked 47 degrees over the main roof and 37 degrees over the flared foot. If the selected handmade tile requires 40 degrees, the drawing is three degrees short at the foot. Ordering a more generous quantity of the same tile would leave the design question exactly where it started. Ask the designer and tile maker to resolve the local geometry or document an appropriate alternative before the order goes out.

Then check the transition between the planes. Mark the headlap, the length protected by the tile two courses above, where courses bend over the change. The association discusses soakers where the required lap cannot be maintained. That is a separate review from minimum pitch. Keep the agreed transition detail alongside the carpenter’s eaves section so that the profile being framed matches the one the tile supplier reviewed. For surrounding terminology see the tile eaves, fascia and gutters guide.

Further reading

Roof Tile Association · Bellcast/Sprocketed Eaves, section through the eaves. The association illustrates UK plain-tile practice. Values depend on the selected tile and applicable project details.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles