Preserving the craft. Building its future.

Slate · Material inspection

How much bow is there in this roofing slate?

Record the span and rise of a bowed slate so the supplier can distinguish curvature from thickness or a local bump.

By the Slate, Tile & Metal Guild ·

A receiving note says “slates vary by an eighth.” The buyer needs to know what was measured. The difference in thickness between two edges, a bulge at one point and the bow across a full piece can all produce the same number on a ruler. Only the last measurement describes curvature across a stated span.

The Slate Roofing Contractors Association’s installation guidelines pair the two dimensions. They set a curvature limit of one-eighth inch over twelve inches and specify that curved pieces be prepared so the outward-bowed face can be laid uppermost. The guidelines discuss raised mineral features separately. A straightedge balanced on a single projection could make the entire piece appear more bowed than it is.

Make a photograph the supplier can interpret

Ask the slater or supplier to demonstrate the agreed check on loose stock at a bench. Show the full piece, its intended exposed end, the length and direction being checked, and the gap used for the reading. Add a close-up of any local projection and note whether it falls in the exposed or covered area. Keep the crate number and piece identifier with both views.

Compare the record with the specified acceptance criteria. An isolated photograph can support a question about one piece. A decision about the delivery needs the project’s sampling or inspection procedure as well. Set aside the pieces under review with their labels so the supplier and slate roofing contractor can examine the same material.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles