Preserving the craft. Building its future.

Slate · Preservation drawings

Should the lower edge of this slate roof be straightened?

Use a documented bell-cast roof to distinguish a change in roof profile from a repair instruction.

By the Slate, Tile & Metal Guild ·

On a side view of an old house, trace the line from the ridge toward the gutter. If the slope eases as it approaches the eave, a drawing that shows one straight line can erase a feature before anyone has decided what to repair.

The National Park Service’s report on the Malus-Beauregard House in Louisiana gives a useful example. The survey describes a shallow flare, called a bell cast, in the lower third of its hipped roof. Figure C84 shows the profile above the gallery. The report separately identifies modern Vermont slate on the slopes and clay tile at the hips and ridge. It lists the roof shape among the building’s character-defining features. A later roof covering can follow an older form.

Give the designer two marks to work with

On the existing elevation, ask the surveyor to mark where the slope begins to change and where the eave ends. Ask for a section through that location. If one corner has also dropped compared with its neighbors, mark that separately for investigation by the design team. The drawing can then identify which curve is to be retained and which local condition requires assessment. A ground photograph is a starting point for that conversation. Earlier views can also help establish whether the sweep predates the present repair. See Slate Roofing USA’s guide to locating earlier roof records.

Further reading

National Park Service — Malus-Beauregard House Historic Structure Report, figures C84–C85. The linked source supplies the example discussed above.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles