Preserving the craft. Building its future.

Clay tile · Custom fabrication

Why is the model for a replacement terra-cotta ridge piece larger than the original?

Separate model dimensions from finished dimensions when reviewing a custom ridge ornament, then check the surfaces that must fit its neighbors.

By the Slate, Tile & Metal Guild ·

A fabricator sends a photograph of a new master model beside the surviving terra-cotta ridge ornament. The new outline looks oversized. Before asking the shop to trim it, find out which stage of manufacture the photograph shows and what finished size the shop has agreed to deliver.

A technical paper on terra-cotta roof restoration published by IIBEC explains why shops enlarge models used to make molds. The clay shrinks during manufacture. The mix and process influence the finished dimensions, and firing can introduce some variation. The fabricator doing the work is in the best position to state its allowance for the selected body and shape. Instructing the shop to copy the old piece at full size at every stage could leave a finished replacement too small to fit.

Measure the places that have to meet

Give separate dimensioned views for the intended fired piece and any manufacturing model submitted for review. Identify two or three controlling measurements on the fired view. For a repeating ridge ornament these might include the distance between end faces, the width of the seat and the position of a fixing opening measured from a named end. State who will approve the acceptable variation at those points.

Ask to see a fired trial piece against the agreed dimensions before releasing a long run. If the joint to a surviving neighbor governs the fit, document that interface as well as the ornament’s silhouette. Keep the approved trial record with the clay roof tile submittal. A later drawing revision can then be checked against the intended roof geometry without confusing it with the larger manufacturing model.

Published by the Guild as part of Tim Kelly’s Slate Boss resource network. These educational guides support project conversations and do not replace an on-site inspection or a project specification.

← All roofing articles